.: Understanding The Purpose Of The Guitar Neck Shim
Some guitars will just NOT adjust properly with the standard methods available like the bridge saddles, nut filing adjustments and the ability to set the bow (or lack thereof) of the neck itself. Adding shims to the bolt on neck may be necessary to get the guitar to play properly at all locations up and down the neck.
A nut shim acts as a spacer between the nut and neck raising and lowering the distance between all of the strings at the lower end of the guitar, starting at fret 1 and moving towards the body of the guitar.
A neck pocket shim acts as a spacer between the neck and body, changing the angle from which the neck protrudes out away from the body.
Try to imagine the strings of your guitar as a flat plane and the fret board as a parallel plane running underneath them. The angle of the top plane which contains the strings is controlled by the position of the tremolo and the nut. The angle of the lower plane which is the fret board is controlled by the neck pocket of the body.
If your setup is perfect these two planes will have an equal distance between them at any point. If your guitar doesn't look this way try adjusting the height of the tremolo itself first. This will usually take care of the problem unless you find your action becoming too high or to low equally across the length of the fret board. If adjusting the height of the tremolo corrects the problem but leaves you with too high or low of an action (distance between the strings and fret board) then you will need to resort to using a shim. You may want to “block” the tremolo before you start the shimming operation.
Shims can be found and used in two different areas of the neck. One is under the nut and the other is directly under the heel in the neck pocket of the body.
Nut shims are usually made out of one or more thin sheets of brass. Shims located in the neck pocket are usually made out of a thin piece of wood. In either case you can produce your own shim if needed by using a sheet of heavy stock paper such as a business card. For shims in the neck pocket you might need to fold the paper stock 3-4 times to get the required thickness needed, then trim to fit properly.
First determine if the distance between the strings and fret board is to close right up against the nut itself. If this is the case then add a shim under the nut and raise the tremolo by adjusting the tremolo posts until the strings are an equal distance from the fret board down the entire length of the neck. If the distance between the strings and the fret board located right up against the nut is OK then you will have to place a shim in the neck pocket to correct your problem as directed below.
If your strings are higher on the Low E side, place the shim in the neck pocket under the heel of the neck and parallel with the length of the neck on the Low E side, which raises the entire neck down the Low E side when it is bolted on. Before doing this check the angle of the tremolo to make sure it is flat against the body and not floating at an angle.
If your strings are higher on the High E side do the opposite, as explained above, by placing the shim parallel to the neck on the High E side in the neck pocket. Again before doing this check the angle of the tremolo to make sure it is flat against the body and not floating at an angle.
If your strings become higher the closer they are to the body place the shim across the neck pocket in the end closest to the neck pickup. This will turn the other end of the neck pocket into a fulcrum point and move the head stock towards the back of the body lowering the strings over the high end frets.
If your strings become lower across the high end frets place the shim across the end of the neck pocket furthest away from the neck pickup. This will raise the headstock away from the back of the body, raising the strings up from the end of the fret board, closest to the body.
In some instances you might find that you need the shim to raise only one corner of the two planes as described above. In these rare cases, make a smaller shim and place it in the appropriate area of the neck pocket. Of course upon removing the nut from the neck or the neck from the body, if you find a shim already there
determine what action it was doing in the first place then make the necessary corrections.
Shimming a guitar neck is definitely an ART. However, if you look at it scientifically, as angles against a plane, you can understand the “how and why” of adjusting a guitar neck this way.
Article keywords: musical instruments, guitar repair, music, guitar
Article Source: http://www.articles32.com
Michael Grainger is a music studio owner and has vast experience setting up guitars for his customers. See more information at Instruments Now
.: New Music Articles
1). Crossing the Musical Generation Gap
This article talks about the experience of a nearing sixty year old amateur guitar player attempting to connect musically with two teenage guitar players and how, eventually, they were able to find a few minutes of musical commonality and appreciation.
2). Piano Lesson: II-V-I Progressions In C Major
Let me give you some easy progressions that will help you in your improvisational piano playing!
3). Tips for Buying an Antique Accordion
Thinking about a purchase of an antique accordion? If so, then you should note first that there are some helpful steps to consider when buying an antique accordion. Few of them are mentioned below.
4). Quick Vocal Warm Ups that Work Wonders
Learn how to get your voice moving early in the morning with tips from a vocal specialist.
5). Gospel Music Artist Says Gospel Music Will Never Be the Same...
Why is there such a tendency toward performing rather than lifting up the Lord in gospel music today?
6). 4 Drum Tips to Keeping Peace With Your Neighbors
There are some quick fixes to help keep your family, friends, and neighbors at peace while still allowing you to drum. Just follow these four solid drum tips...
7). Discover How Lil Wayne Is All About Making Music
Lil Wayne aka Weezy Baby is a talented rapper who gives you an unique version of hip hop music and the youth culture.
.: Top Music Articles
1). Make Your Own Beats, Instrumentals, Tracks, and Demo CDs
Many people are making an excellent living selling thier samples, tracks, and cd's, on the Internet and off, even if they're not with a major record label. Just look around on the Internet. People are paying $30 to $60 for small beat and and sound packages, $50 to $100 for small loopsets and beatsets, $100 to $300 for Instrumentals, $100's to $1,000's for complete tracks and samples, and for the few lucky ones like Jay-Z and J D.
2). Understanding The Purpose Of The Guitar Neck Shim
Some guitars will just NOT adjust properly with the standard methods available like the bridge saddles, nut filing adjustments and the ability to set the bow (or lack thereof) of the neck itself. Adding shims to the bolt on neck may be necessary to get the guitar to play properly at all locations up and down the neck.
A nut shim acts as a spacer between the nut and neck raising and lowering the distance between all of the strings at the lower end of the guitar, starting at fret 1 and moving towards the body of the guitar.
3). Ukulele Tab: Learn To Play Morning Has Broken On Your Ukulele
An ukulele is used mostly to play chords to songs. But you can also play melodies. Today you will learn to play Morning Has Broken on your ukulele!
4). 4/4 Rhythm Strumming
If you are learning how to play the guitar, the basic 4/4 strumming technique is one of the first guitar playing techniques that you must be able to master.
5). Music Production and Mixing Tips & Tricks
What makes a pro recording pro? What is the "sound" that the pros get and how can you make your recordings sound more professional?
The simple answer is - there's no simple answer. But with careful listening and a little experience you can create excellent results with modest equipment.
Good mixing starts ear
The first and most important item of.
6). Creating The Perfect Structure For Your Song
You know what they say about rules? Actually they say lots of things about rules but here's two - rules were made to be broken, and you have to know what the rules are before you can break them. While Judge Dredd may not agree with the first, the second is certainly true and nevermore so than in writing a song.
The song structure may not be the first thing you think about when you start writing.
7). Visual Kei As a Music World Vision
Visual Kei appears to be frequently used in videos and grab audience’s attentions. Visual Kei followers are characterised by a rather stunning, although freak appearance of a striking make-up and elaborate costumes, causing a shock effect.
To recall, for instance, Merlyn Manson, who is among few to follow the style in the US. The trend is popular among modern bands, irrespective of rumours, suggesting that the style suffered no popularity in the USA and Europe.