.: What's a 3/2 compressed air valve?
By:Bill Wade
Recently, I published an article on this site titled: What's a 2/2 compressed air valve? Here, in the next installment in this series, is information on a slightly more complex air valve; the 3/2 style.
The first number in the 3/2 air valve, the three, refers to the number of "working" air ports that are found in the valve body. That is, the number of ports that supply air to the valve, and channel the compressed air to whatever it is that the valve is supposed to do.
Most 3/2 valves will have numbers or letters etched, cast or painted near each of their three "working" air ports. If there are numbers near the ports, the number 1 would be the supply port to bring the compressed air to that valve.
Port number 2 would be the working port from which air would flow to accomplish whatever task that you wanted that valve to do.
The third port in a 3/2 air valve is an "exhaust" port and if numbered, it could be a 3 or a 5. If the port designations in a 3/2 valve are letters, then port 'A' would be the supply port and port 'B' the working port, with the third port normally being an 'E'.
As in the 2/2 valve there may be one or two additional ports in the ends of the 3/2 valve to allow an air signal line or lines to be connected. If this is the case, this 3/2 valve will either be single, or double air piloted.
The 2 in a 3/2 air valve indicates the number of positions that the internal valve mechanism has. In this case, two. When this valve is operated or actuated, it will either open or close and air will either flow to the application upon actuation, or it will be prevented from flowing.
Most 3/2 compressed air valves will be NC, or normally closed. When the valve is not actuated, it's normal state is closed, and compressed air cannot pass through it.
If your application calls for air to flow through the valve when it's not actuated, that the circuit needs air to be flowing through this valve when it is at rest, then a NO or normally open configured valve would be selected.
All 3/2 valves have actuators that will operate or 'shift' the air valve. An external button, or toggle, or perhaps a solenoid actuator would be the visible actuator. Inside, there will likely be an internal actuator – a spring - which will shift the valve to the off position when the external actuator is not being used.
If the external actuator is 'detented', then when the valve is operated, it will stay in it's last selected position until an operator changes it. Detented means it will stay where it's put! This is useful when an operator needs to actuate the valve, and then manually perform another operation while the air valve feeds air to the application.
Unlike it's less complex 2/2 valve cousin, the 3/2 valve is used when a compressed air supply is needed to an application or device that uses compressed air to power it, yet in itself has no integral air pathway to atmosphere. Therefore, when the device has performed it's function, and it's time to 'deflate' it or to let the compressed air back out, the third port in the 3/2 valve comes into play.
When the compressed air supply through the valve is shut off internally, a pathway back through the valve to atmosphere will be opened, to allow the compressed air to escape. The air supply is shut, so the compressed air flowing to the valve cannot flow through it, and the compressed air that was formerly in the device or application can now bleed back down the air line through the valve to exhaust.
So, what type of devices are these?
Usually they are single acting type actuators. One comes to mind immediately; "Air springs".
Both Firestone and Goodyear (among others) manufacture "air springs". These are devices that look like tires, but rather than have an opening in the middle of the doughnut where the rim goes, they are closed on both sides with steel plates. In one side there will be an air port to which an air line from a 3/2 valve can be connected. These "air springs" are mounted on their sides, picture a tire lying flat after you've taken it off your car, and can generate huge actuation forces. Force equals pressure times area, and the “piston” size inside an air spring can be huge. The application of air springs mirrors that of typical air cylinders, yet offer large capacity at a fraction of the cost of an air cylinder of a necessary size to generate the same force as the air spring.
Another application for 3/2 valves is single acting air cylinders. Whether they are spring extend or spring retract, an air supply is required to operate the SA cylinder. A 3/2 valve is designed to do just that.
A couple of more points; the 3/2 valve can have the exhaust port plugged, and voila, you have a 2/2 valve.
If the cost of the valve is the same, you can use a 3/2 air valve anywhere you might use a 2/2 valve. Since 2/2 valves always have to have the “working port” ultimately plumbed to atmosphere, that there is an exhaust port in a 3/2 valve offers no obstacle to it’s use.
If you have a double acting air cylinder, and you don't have a 4/2 or 5/2 (more on these valves next article) available, you can use two 3/2 valves to operate any cylinder that requires two supply lines in order for it to extend and retract.
At ABOUT-air-compressors.com my e-book entitled All About Air Valves - Volume One is now available. If you are interested in more information about air valves, do visit the site and download a copy. This first e-book is an introduction to air valves, and focuses on the 2/2 iteration. Future volumes will focus on 3/2 valves, and then the 4/2 & 5/2 configurations.
And as always, if you have any questions, please send me a message from the contact screen at my web site.
Article keywords: air valve, compressed air, air compressor, valves, types of valves, air filters, air lines, working with compressed air
Article Source: http://www.articles32.com
Bill Wade's experience in compressed air and other industries spans decades; from field sales positions through to the corporate presidential office. His sales agency represents a select group of industrial firms. Mr. Wade writes about all facets of compressed air at www.about-air-compressors.com.
.: New Hobbies Articles
1). Shopping For Radio Controlled Helicopter - Tips To Help You Choose
If you are looking for a radio-controlled helicopter, the most difficult question to answer is: "what should I buy?". Bear in mind that if you skip to answer this question, then you might be ending up with a one time flying experience. In other words, after you have bought and first flown your radio-controlled helicopter, you might not be able to fly it again.
2). Why I Do My Woodworking Using Hand Tools
Some woodworkers avoid hand tools at all costs. They think that they are outdated, less accurate and slower than the modern day machines. This simply is not true in most cases.
3). Ballerina Music Box - for Lovers of Music
A ballerina music box can make a perfect present for any woman. These boxes are so delicate and beautiful, and they are rather rare gifts. See how you can find a music box that will make you friend or family member smile every time she looks at it.
4). Starting Model Helicopter Hobby - How To Choose The Right Helicopter
Choosing the right one for you depends on these criteria. For example, if you want a cost effective helicopter strictly for personal use, you can take the Schweizer 300 or the Robinson R22 (helicopter for 2). It has basic comfort and few features. The exact opposite are the McDonnell-Douglas 500, Enstrom Shark, and the Agusta 109A. They are fast and more convenient to fly.
5). The Joy Of Boating
Listening to the sounds of the water flowing as your boat cruising on the lake or any water surfaces in the world can be truly enjoying...
6). Tips And Tricks For Phenomenal Winter Fly Fishing
Fly fishers come out in the spring, casting their fishing flies out over water in the early morning sun.
7). Learning To Play Guitar By The Ear
Learning how to play a guitar can be accomplished through different methods depending on your convenience and aptitude.
.: Top Hobbies Articles
1). Orchid Care - Phaleanopsis Orchids
--An introduction to Phalaenopsis orchids.
Phalaenopsis orchids are one of the easiest orchids to grow in the home. The name "phalaenopsis" comes from the Greek phalaina, meaning "moth" and opsis, meaning "like". For this reason this orchid goes by the nick name "Moth Orchid".
These orchids are very easy to grow and flower as long as care is given to recreate their natural growing environment as much as possible.
2). History of Candle Making
Who invented the candle?
Candles were invented independently in many countries. The Egyptians and Cretans made candles from beeswax, about 3000 BC. In the fourth century BC there were clay candle holders in Egypt. Qui Shi Huang (259 - 210 BC) was the first Emperor of the Qin Dynasty (221 - 206 BC). His mausoleum was rediscovered in the 1990s 22 miles east of Xi'an in China and contained candles made from whale fat.
3). Skydive To The End
A skydiver usually travels at the speed of 12,000 feet or 4000 meters altitude and free falling from the sky.
4). Yugioh Trading Card Game Etiquette: Rules For Respectful Play
The Yugioh trading card game has grown in popularity, with avid players in countries across the world. Dedicated players everywhere are familiar with the specific and elaborate set of rules of etiquette that govern an official round of battle. The official guide to the Yugioh trading card game urges players to proceed with much decorum. Here is a brief guide to exercising maximum Yugioh etiquette.
5). The Characters Of Yugioh
The wildly popular Yugioh franchise has spawned a number of popular characters that are familiar to fans worldwide. If you’re new to the world of Yugioh, here is a run-down of the most popular Yugioh characters.
The main character in the Yugioh series is Yugi Moto. On the outside, Yugi Moto appears to be a shy and reserved student at Domino High School, but he leads a secret life of danger and excitement.
6). Night Fishing for Speckled Trout
Fishing for speckled trout at night tips and lures for your next fishing adventure.
7). How to Use the Different Noises to Attract Deer
There are some who believed that deer could be called with some noise. And some even use what they called deer calls found in the market.